@article{PastekaSantosdaCostaBarrosetal.,
  author    = {Pasteka, Richard and Santos da Costa, Joao Pedro and Barros, Nelson and Kolar, Radim and Forjan, Mathias},
  title     = {Patient-Ventilator Interaction Testing Using the Electromechanical Lung Simulator xPULMTM during V/A-C and PSV Ventilation Mode},
  series = {Applied Sciences},
  volume    = {11},
  journal   = {Applied Sciences},
  number    = {9},
  abstract  = {During mechanical ventilation, a disparity between flow, pressure and volume demands of the patient and the assistance delivered by the mechanical ventilator often occurs. This paper introduces an alternative approach of simulating and evaluating patient-ventilator interactions with high fidelity using the electromechanical lung simulator xPULM™. The xPULM™ approximates respiratory activities of a patient during alternating phases of spontaneous breathing and apnea intervals while connected to a mechanical ventilator. Focusing on different triggering events, volume assist-control (V/A-C) and pressure support ventilation (PSV) modes were chosen to test patient-ventilator interactions. In V/A-C mode, a double-triggering was detected every third breathing cycle, leading to an asynchrony index of 16.67\%, which is classified as severe. This asynchrony causes a significant increase of peak inspiratory pressure (7.96 ± 6.38 vs. 11.09 ± 0.49 cmH2O, p < 0.01)) and peak expiratory flow (-25.57 ± 8.93 vs. 32.90 ± 0.54 L/min, p < 0.01) when compared to synchronous phases of the breathing simulation. Additionally, events of premature cycling were observed during PSV mode. In this mode, the peak delivered volume during simulated spontaneous breathing phases increased significantly (917.09 ± 45.74 vs. 468.40 ± 31.79 mL, p < 0.01) compared to apnea phases. Various dynamic clinical situations can be approximated using this approach and thereby could help to identify undesired patient-ventilation interactions in the future. Rapidly manufactured ventilator systems could also be tested using this approach. View Full-Text},
  subject      = {Breathing Simulation},
  language  = {en}
}
@inproceedings{PastekaSantosdaCostaForjan,
  author    = {Pasteka, Richard and Santos da Costa, Joao Pedro and Forjan, Mathias},
  title     = {Characteristic Waveforms for Testing of Medical Aerosol Inhalers},
  series = {8th European Medical and Biological Engineering Conference},
  booktitle = {8th European Medical and Biological Engineering Conference},
  publisher = {Springer International Publishing},
  pages     = {240 -- 246},
  abstract  = {Respiratory diseases are characterised by high prevalence among the European population. Medical aerosol inhalers are the most commonly used means of drug delivery into the human respiratory system. This paper focuses on characteristic waveforms that can be utilised during aerosol deposition studies to simulate conditions of rapid human inhalation. Additionally, an inhalatory waveform based on clinically recorded spirometry data is introduced. Experimental measurements are performed and simulation results mutually compared using the electro-mechanical lung simulator xPULM. The inhalatory waveforms are repeatably simulated with high fidelity in regards to the waveform shape with the lowest value of the Goodness of fit 0.89. Additionally, the measured values for all characteristic inhalatory parameters are simulated with low standard deviation < 1. The differences between the required and measured waveform shapes are small, < 3 L/min and do not influence the overall inhalatory volume. This opens a possibility of utilising the xPULM for medical aerosol inhalers testing.},
  subject      = {Breathing Simulation},
  language  = {en}
}